Connection With An Av Receiver - Kenwood DVF-9010 Instruction Manual

Connection with an AV receiver

16
This unit incorporates a Dolby Digital (AC-3) decoder and MPEG multi-channel decoder. As a result, it can play DVD discs
encoded with Dolby Digital (AC-3) or MPEG multi-channel without the need of purchasing a commercially available Dolby
Digital (AC-3) decoder.
A DTS-encoded CD or DVD disc cannot be played. Noise may be produced if such a disc is played.
The output audio is variable depending on the played discs and setups. By referring to the following table, perform initial setup
and other settings according to your system. ("Changing the initial setup"
Played Disc
DVD
VCD
CD
(*1) When the [7 Digital Audio Output] of the initial setup is set to "1 Off", a DVD with a sampling frequency of 48 kHz (20 bit/
24 bit) or 96 kHz cannot be played back. (Changing initial setup [7 Digital Audio Output]
About the linear PCM audio
This is the signal recording format used with music CD discs. While music CDs use 44.1 kHz/16-bit recording format, DVDs use from 48 kHz/16-bit
to 96 kHz/24-bit formats so they can reproduce audio with a higher quality than music CDs.
Audio Recording
System
Dolby Digital (AC-3)
Linear PCM
MPEG Multi
MPEG 1
Linear PCM
q
)
Output Audio
Analog Output
6ch
2ch
6ch (max.)
2ch
2ch
System Connections
DVF-9010 (En/E)
Digital Output
•Bitstream
•PCM (48kHz/16bit) 2ch
(*1)
PCM (48kHz/16bit) 2ch
•Bitstream
•PCM (48kHz/16bit) 2ch
PCM (44.1kHz)
PCM (44.1kHz)
i
)