Operation Of Remote Control Unit; Loading Batteries; Operation; Remote Control Mode Switch - Kenwood DVF-9010 Instruction Manual

Operation of remote control unit

Loading batteries

1 Remove the cover.

Operation

Insert the power plug into a power outlet, press the POWER
key of the main unit to ON, then press the desired remote
control key.
÷ When pressing more than one remote control keys successively, press
the keys securely by leaving an interval of 1 second or more between
pressing of keys.
Notes Notes
1. The provided batteries are intended for use in operation checking, and
their service life may be short.
2. When the remote controllable distance becomes short, replace both
of the batteries with new ones.
3. If direct sunlight or the light of a high- frequency fluorescent lamp
(inverter type, etc.) is incident to the remote sensor, malfunction may
occur. In such a case, change the installation position to avoid
malfunction.

Remote control mode switch

Before starting remote control operation, be sure to set the
mode switch according to the play modes and keys to be
controlled.
Switch
2 Insert batteries.
÷ Insert two R6 ("AA"-size) batteries follow-
ing the polarity indications.
DVD
CD
DVD
SET UP
3 Close the cover.
Remote sensor
6m
30°
Reference operating range

Joystick operation

The joystick allows you to select or enter an icon or item
displayed on the TV screen.
Basic operation
1 Tilt the joystick to the direction of one of the arrows
(%, fi, @, #) to select an icon displayed on the TV
screen.
2 Press the ENTER key to enter the selection.
1
DVF-9010 (En/E)
2
1
30 °
8
¡
ENTER
21