Connection To Digital Amplifier Or M D; Connection To A General-Use Amplifier - Kenwood CD-224M Instruction Manual

Connection to digital amplifier or M D

Connect the DIGITAL OUT (OPTICAL) jack to the digital input jack
of the amplifier, DAT recorder, M D recorder, etc., using an optical
fiber cable w hich are commercially available in audio stores.
÷ When using an optical fiber cable to connect this unit to a digital
amplifier, insert the plug straight into the jack until a snap sound is
heard.
÷ Be careful not to bend, coil, or bundle the optical fiber cable.
÷ Optical fiber cables available on the market may not alw ays be able to
be used w ith this player. If your cord cannot be used w ith this unit,
consult the store from w hich you purchased the cord or your nearest
dealer.

Connection to a general-use amplifier

Use the provided audio cords to connect the OUTPUT jacks of this
unit to the CD input jacks (or AUX jacks) of the amplifier.
SYSTEM CONTROL CONNECTIONS
Connecting system control cords after connecting a KENWOOD
audio component system lets you take advantage of convenient
system control operations.
There are tw o KENWOOD system control modes. M ake connec-
tions according to the groups of terminal symbols show n below.
: lets you combine F , f , and ƒ terminals
[XS8] M ode
[SL16]M ode : for
This unit is compatible w ith both [XS8] and [SL16] modes.
Select the mode according to the connected components.
÷ Do this operation after completing all connections.
(Ensure that the pow er plug is not connected.)
1. If your amplifier or receiver does not have a system control
terminal, do not connect any system control cords to the
Notes Notes
system control terminals on the other components.
2. Do not connect system control cords to any components
other than those specified by KENWOOD. It may cause a
malfunction and damage your equipment.
3. Be sure the system control plugs are inserted all the w ay
in to the system control terminals.
SYSTEM CONTROL OPERATIONS
Remote Control
Lets you operate this unit w ith the system remote control unit supplied w ith the amplifier or receiver.
Automatic Operation (Except [XR] equipment)
Automatically sw itches the input selector on the amplifier or receiver w hen you start playback from this unit.
Synchronized Recording (Except [XR] equipment)
Lets you synchronize recording w ith the start of playback w hen recording from a CD. Also, the simple CCRS operation enables great recordings from
CDs.
See the operating instructions supplied w ith your cassette deck for details.
Downloaded from: http://www.usersmanualguide.com/
terminals only
SL1 6 XS 8
j
CON TROL
CON TROL
6
CON TROL
CD-2 2 4 M / DPF-J5 0 1 0 (En)
Optical fiber cable
Amplifier or receiver
SYSTEM
This unit
SYSTEM
Cassette deck
SYSTEM
System connections
7