Kenwood DVF-9010 Instruction Manual page 49

Dvd/vcd/cd player

Service manual (58 pages)

Table of Contents

Recommended setup for [7 Digital Audio Output]

The recommended setup for [7 Digital Audio Output] is variable depending on the equipment connected to the digital audio

output. Set up this item by referring to the following table.

Digital Audio Output Connection

When no equipment is connected

When an amplifier having a digital input but not incorporating

a Dolby Digital (AC-3) decoder is connected

When a Dolby Digital (AC-3) decoder is connected

When a MPEG multi-channel decoder is connected

(*1) The signal from the audio output of the player is converted into a 48 kHz/16-bit signal just like the signal output from the digital audio output. Therefore,

if you want to play high audio quality software with 48 kHz/20-bit or 24-bit or 96 kHz recording, do not connect the equipment such as an amplifier or

decoder to the digital audio output (i.e. set [1 LPCM (DVD)] to "1 Off") and connect the equipment directly to the audio output jacks.

(*2) Set to "PCM" when connecting the equipment other than a Dolby Digital (AC-3) decoder. If this item is set to "Bitstream", loud noise may be produced

and speakers may be damaged.

(*3) When this item is set to "PCM", any other speaker than the front speakers is set to other option than "Off" in [8 Speaker Setting] and a DVD with

Dolby Digital 6-channel surround recording is played, the digital audio output outputs only the front 2-channel components.

If this occurs, set other speakers than the front speakers to "Off" in [8 Speaker Setting].

(*4) Noise may interfere with the speaker output if the player is connected to a piece of equipment which does not incorporate an MPEG multi-channel

decoder. Never connect the player to equipment without a built-in MPEG multi-channel decoder.

[7 Digital Audio Output] Setup

1 LPCM (DVD)

Off (Factory setup)

Bitstream (Factory setup)

PCM (*1)

PCM (*2)(*3)

Bitstream

PCM (*1)