Kenwood DVF-9010 Instruction Manual page 59

DVD player unit
Symptom
Playback will not start even after a title is
selected.
The viewing restriction level (RATING) can-
not be changed.
The voice or subtitle language selected in
the initial setting is not played.
No message appears on the TV screen after
a key is pressed.
Menu screen messages are not shown in the
desired language.
Audio is not reproduced in surround sound.
Remote control unit
Symptom
Remote control operation is not possible.
Inhibition icon
Symptom
The inhibition icon is displayed
and remote control is not pos-
sible.
Cause
÷ A viewing restriction (RATING) has been set for
the disc.
÷ You have forgotten the viewing restriction (RAT-
ING) password.
÷ The DVD disc being played does not contain the
recording of the selected voice or subtitle lan-
guage.
÷ The function for displaying message on the TV
screen (On-Screen Messages) is set to off.
÷ The menu language function (MENU) is not set.
÷ The surround speakers are set to "Not used" in
the speaker mode [8 Speaker Setting].
Cause
÷ Batteries are exhausted.
÷ The remote control is too far away from the
system, the controlling angle is deviated or
there is an obstacle in between.
Cause
÷ Playback is restricted intentionally by the soft-
ware producer.
In case of difficulty
Remedy
÷ Check the viewing restriction level (RATING)
setting.
÷ Set the initial setup to the factory setup with
the following procedure.
While holding the 7 key, press and hold the 8
key until "INITIAL OK!" appears.
÷ Use a DVD disc containing the recording of
the selected voice or subtitle language.
÷ Set On-Screen Messages to on.
÷ Set the disc menu language function (MENU)
as required.
÷ Set the surround speakers to "Used" in the
speaker mode setting of initial setup [8
Speaker Setting].
Remedy
÷ Replace with new batteries.
÷ Operate the unit inside the remote control-
lable range.
Remedy
÷ The operation is inhibited. Please try another
operation.
DVF-9010 (En/E)
59