Power Distribution Boards; Removing A Power Distribution Board - Dell PowerEdge C6220 Hardware Owner's Manual

2 Connect the fan cable to the connector on the cooling-fan cage.
3
Align the cooling-fan cage with the locating pins on the chassis and
place it into the chassis until it's firmly seated in place. See Figure 3-52.
4 Connect the fan's power cable to the connector on the power
distribution board 1. See Figure 3-52.
You must route these cables properly through the ties to prevent them
from being pinched or crimped.
5
Close the system. See "Closing the System" on page 191.
6 Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.

Power Distribution Boards

Removing a Power Distribution Board

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
NOTE: This system has two power distribution boards. The procedure to remove
and install both the power distribution boards is similar. To access the second
power distribution board at the bottom, remove the power distribution board at
the top.
1 Recommend to turn off the system, including any attached peripherals,
and disconnect the system from its electrical outlet.
2 Open the system. See "Opening the System" on page 190.
3 Remove the power supply. See "Removing and Installing a Power
Supply" on page 121.
Installing System Components | 195