Command Line Interfaces For Setup Options - Dell PowerEdge C6220 Hardware Owner's Manual

Option
Load 2nd Defaults
Save 2nd Defaults

Command Line Interfaces for Setup options

The options of SETUP menu allow the user to control by system
configuration utility (syscfg), the utility includes in Dell OpenManage
Deployment Toolkit (DTK).
Users can use the utility as following:
•
To change the SETUP option by D4 token:
./syscfg –t=D4_token_id
(Example: ./syscfg -t=0x002D to enable NIC1)
•
To check token active status:
./syscfg --istokenactive=D4_token_id
(Example: ./syscfg --istokenactive=0x002D to check the token
active status of NIC1)
•
To change the SETUP option thru BMC memory directly:
./ipmitool raw <command> <data>
(Example: ./ipmitool raw 0xc 1 1 3 10 106 42 120 to set IP address
of BMC LAN port as 10.106.42.120)
Description
Load second default values for all the setup questions.
This item only selectable if 2nd Defaults was saved
before.
The first time to save 2nd Default in setup, the item
will not be displayed immediately, only available from
the next boot.
Save all setup questions' current value as second
default.
Installing System Components | 81