Installing The Lsi 9265-8I Card For 1U Node - Dell PowerEdge C6220 Hardware Owner's Manual

Figure 3-25. Removing the BBU Interposer Card
1 BBU interposer card

Installing the LSI 9265-8i Card for 1U Node

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
CAUTION: Expansion cards can only be installed in the slots on the expansion-
card riser. Do not attempt to install expansion cards directly into the riser
connector on the system board.
CAUTION: Not to apply any pressure to heat sinks on expansion cards.
1
Unpack the LSI 9265-8i card and prepare it for installation. For
instructions, see the documentation accompanying the card.
2 Remove the system-board assembly. See "Removing a System-Board
Assembly" on page 124.
3 Connect the RAID battery cable to the BBU interposer card. See
Figure 3-26.
2 LSI 9265-8i card
Installing System Components | 149