Cable Routing For Lsi 9265-8I Card (1U Node) - Dell PowerEdge C6220 Hardware Owner's Manual

4 Install the BBU interposer card onto the LSI 9265-8i card. See Figure
3-25.
5 Remove the screw securing the filler bracket. Grasp the filler bracket by
its edges, and carefully remove it from the expansion-card connector.
NOTE: Keep this bracket in case you need to remove the expansion card.
Filler brackets must be installed over empty expansion-cards slots to
maintain FCC certification of the system. The brackets also keep dust and
dirt out of the system and aid in proper cooling and airflow inside the
system.
6 Connect the mini-SAS/SGPIO cables to the LSI 9265-8i card assembly.
See Figure 3-26.
7
Holding the card by its edges, position the card so that the card-edge
connector aligns with the expansion-card connector.
8 Insert the card-edge connector firmly into the expansion-card
connector until the card is fully seated.
9 Replace the screw securing the LSI 9265-8i card.
10 Place the LSI 9265-8i card assembly into the system-board assembly.
11 Replace the four screws that secure the LSI 9265-8i card assembly.
12 Install the system-board assembly. See "Installing a System-Board
Assembly" on page 125.

Cable Routing for LSI 9265-8i Card (1U Node)

1 Connect the mini-SAS cable to the LSI 9265-8i card, and connect the
other end of the cable to the corresponding connector on the system
board.
2 Connect the mini-SAS&SGPIO cable to the LSI 9265-8i card, and
connect the other end of the cable to the corresponding connectors on
the system board. Make sure the cables should go through the cable
clip ring. See Figure 3-26.
150 | Installing System Components