Cable Routing For Sensor Board And Front Panel For 2.5" Hard Drive System - Dell PowerEdge C6220 Hardware Owner's Manual

7 Connect all the cables to the backplane. See Figure 3-73 for 2.5-inch
hard drives.
You must route these cables properly on the chassis to prevent them
from being pinched or crimped.
8 Connect front panel cables to the power distribution board. See Figure
3-80 or Figure 3-83.
You must route these cables properly on the chassis to prevent them
from being pinched or crimped.
9
Close the system. See "Closing the System" on page 191.
10 Replace the hard drives. See "Installing a Hard Drive into a Hard-Drive
Carrier" on page 119.
11 Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.
Cable Routing for Sensor Board and Front Panel for 2.5" Hard Drive
System
1
Connect the Y-shaped cable for sensor board and front panel 2 to the
connector on the power distribution board 1, and connect the other
two ends of the cable to the connectors on the sensor board and the
front panel 2 separately.
2 Connect the front panel cable to the connector on the power
distribution board 1, and connect the other end of the cable to the
connector on the front panel 1.
Installing System Components | 237