Backplane Jumper Settings - Dell PowerEdge C6220 Hardware Owner's Manual

Backplane Jumper Settings

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
The function of jumpers installed on 3.5" backplane and 2.5" backplane is
the same. Following is an example using the jumpers installed on 3.5"
backplane.
Figure 5-15. Jumper Installed on Backplane
Table 5-2. Jumpers Installed on Backplane
Jumper
SW1 (pin1-2)
SW2 (pin3-4)
SW3 (pin5-6)
SW4 (pin7-8)
NOTE: The * in the table of backplane jumper describes the default status and the
default state is not active state.
268 | Jumpers and Connectors
Function
Reserved
Reserved
2
SGPIO I C Select
MFG Test
Off On
*Disable Enable
*Disable Enable
*Disable Enable
*Disable Enable