Document Processor - Kyocera KM-2530 Operation Manual

CHAPTER 7 OPTIONAL EQUIPMENT
2 Set the originals on the original table in correct sequence
with the side to be copied facing upward. Securely in-
sert the leading edge of the originals into the Document
Processor as far as they will go.
* When setting large size paper such as 8 1/2" ✕ 11",
A4R or larger, pull out the support extension.
IMPORTANT
• Do not set originals exceeding the limit indicated on the sticker
attached on the rear original insertion guide. Setting more origi-
nals than specified may cause original misfeed.
5 5 5 5 5 How to set originals on the platen
When using an original that cannot be set in the Document Pro-
cessor, such as a book or magazine, open the Document Pro-
cessor and place it on the platen.
1
Hold the Document Processor open/close handle and
open the Document Processor.
* Before opening the Document Processor, check that
no original is present on the original table or original
eject cover. If present, the original may fall off when the
Document Processor is opened.
7-2
2 Set the original with the side to be copied facing down-
ward.
Be sure to align the original with the original size scales.
3
Hold the Document Processor open/close handle and
close the Document Processor.
IMPORTANT
• Do not press the Document Processor against the platen with
force. Doing so many cause damage to the glass material.
CAUTION
DO NOT leave the document processor open as
there is a danger of personal injury.

(2) Document Processor

This document feeder automatically feeds and scans each origi-
nal, one by one, for copying. Refer to Duplex Document Proces-
sor for detailed information on how to use the Document Proces-
sor.
IMPORTANT
• Document Processor does not have the original set indicator.
• Document Processor can be used only for Copiers with a copy
speed of 25 copies per minute.