Chapter 7 Optional Equipment; Duplex Document Processor - Kyocera KM-2530 Operation Manual

CHAPTER 7

(1) Duplex Document Processor

The Duplex Document Processor automatically feeds one-sided
originals one by one for scanning. It also reverses two-sided origi-
nals automatically for duplex copying and page separation copy-
ing.
1 1 1 1 1 Originals that can be used with the Document Processor
Sheet originals only
• Original weights: Single-sided original of 35 g/m
two-sided original of 50 g/m
• Original sizes: 11" ✕ 17"/A3 (maximum) to 5 1/2" ✕ 8 1/2"/A5R
(minimum)
• Capacity: 100 sheets ( 8 1/2" ✕ 11"/A4 and smaller,
75 g/m
70 sheets (8 1/2" ✕ 14"/Folio and larger,
75 g/m
30 sheets in auto selection mode
2 2 2 2 2 Precautions for the use of Document Processor
Do not use any of the originals given below with the Document
Processor. Also do not set originals with punch holes or tear-off
strips positioned at the leading edge.
• Transparency films
• Carbon paper and extremely creased or folded originals, origi-
nals of sort material such as vinyl
• Non-square originals, wet originals, originals with adhesive tape
or glue
• Originals bundled with a paper clip or staple (if inevitable, re-
move the paper clip or staple and straighten out the creases
and folds before setting the originals)
• Clipped out originals, originals with slippery surface
• Originals with still-wet whiteout
• Originals with creases (if inevitable, straighten out the creases
before setting the originals)
OPTIONAL EQUIPMENT
2
to 160 g/m
2 2
to 120g g/m
2 or 80 g/m 2 )
2 or 80 g/m 2 )
3 3 3 3 3 Document Processor part names
6
3
4
1 Original table
(Place the originals here.)
2 Original insertion guides
(Adjust the guides to the width of the originals.)
3 Document Processor open/close handle
(Hold this handle when opening and closing the Document
Processor.)
2
4 Original eject cover
(Copied originals are stored here.)
5 Document Processor original cover
(Open this cover to remove an original misfed in the Docu-
ment Processor.)
6 Original set indicator
(Lights green when the originals are set.)
4 4 4 4 4 How to set originals in the Document Processor
1 Adjust the original insertion guides to the original size.
NOTE
• Before setting the originals in the Document Processor, check
that no original from the previous operation is remaining on the
original eject cover. Originals remaining on the original eject
cover may cause original misfeed.
2
5
1
7-1