Kyocera KM-2530 Operation Manual page 117

5
Press the [Start] key. Scanning of the originals will start.
The number of scanned originals will be displayed.
NOTE
• Repeat this operation for all originals when using the platen.
6
After all the originals have been scanned, press the
[Scanning finished] key.
Copying will begin and the copies will be automatically
stapled and ejected face down onto the tray.
7 Remove all of the finished copies from the tray.
4 4 4 4 4 Copying in the Hole Punch mode (optional)
Copies can be automatically hole punched.
1
Press the [Sort/Finished] key.
The "Sort/Finished" screen will appear.
Inch specifications
Metric specifications
2
Press the [Punch mode] key.
The hole "Punch" screen will appear.
Inch specifications
Metric specifications
IMPORTANT
• When the optional punch unit is not installed, the [Punch mode]
key will not appear.
3
4
IMPORTANT
7 • The position of the holes on each page may differ very slightly
due to the fact that holes are punched in one sheet at a time.
5
6
7
NOTE
• Repeat this operation for all originals when using the platen.
7
CHAPTER 7 OPTIONAL EQUIPMENT
Touch the [2 holes] key. The staple position set screen
will appear.
Inch specifications
Metric specifications
Press the key that corresponds to the desired position
of holes.
* Hole punching will be accomplished as shown in the
illustration (as viewed from the front of the copies).
A
A
Set the originals to be copied.
Press the [Start] key. Scanning of the originals will start.
The number of scanned originals will be displayed.
After all the originals have been scanned, press the
[Scanning finished] key.
Copying will begin and the copies will be automatically
punched and ejected face down onto the tray.
7
7
7-5