Chapter 3 How To Load Paper; Loading Paper Into The Multi-Bypass - Kyocera KM-2530 Operation Manual

CHAPTER 3 HOW TO LOAD PAPER

Set the paper flush against the left-hand wall of the
4
drawer.
IMPORTANT
• There is a sticker (1 in the illustration) indicating paper capac-
ity attached to the inside of the drawer. Do not load paper above
this limit.
• When loading paper into the drawer, make sure that the copy
side is facing upward. (The copy side is the side facing upward
when the package is opened.)
• Check that the length adjustment plate makes secure contact
with the paper. If there is a gap, adjust the position of the length
adjustment plate.
• If small-size paper jams frequently under high temperature and
high humidity conditions, reduce the number of sheets to the
level of the black line indicated on the sticker 1.
5 Set the supplied paper size sheet so that the size of the
paper loaded can be checked by looking at the front of
the drawer.
6
Gently push the drawer back in.
* Check that the paper is kept under the claws of the
drawer. If not, reload the paper.
3-2
1
NOTE
• Before leaving the copier in disuse for a prolonged period of
time, remove the paper from the drawer(s) and seal it in its origi-
nal packaging to protect from moisture. Also, when storing pa-
per in a high temperature and high humidity environment, seal
it in a moisture-proof bag.

(3) Loading paper into the multi-bypass

Special paper as well as standard paper can be loaded into the
multi-bypass. When copying onto transparencies or thick paper,
be sure to use the multi-bypass.
NOTE
• Up to 200 sheets of standard paper, colored paper and letter-
heads can be loaded into the multi-bypass.
• The types of special paper and the number of sheets that can
be loaded in the multi-bypass are:
- Transparencies: 25 sheets
- Standard paper (120g/m
IMPORTANT
• When setting special paper, such as transparencies and thick
paper, into the multi-bypass, select the type of paper by refer-
ring to "Check bypass sizing" on page 6-16.
• For the copier with Inch Specifications:
When loading the transparency on the multi-bypass, put a same
size paper under the transparency and set together on the multi-
bypass.
Otherwise, a last transparency would not be fed.
1 Open the multi-bypass.
2 Adjust the insert guides to the size of the paper to be
loaded.
2 , 160g/m 2 ): 100 sheets