Table of Contents
Advertisement
D-Link DES-3010PA User Guide
Viewing the Device
The D-Link DES-3010PA Fast Ethernet Switch is an 10 port managed switch. The device contains 8 network ports
on the front panel for network connectivity, a fiber Gigabit port and a Gigabit Small Form-factor Pluggable (SFP)
port to provide an uplink to a server and a network backbone, and a console port for the device configuration.
Device management is performed using an Embedded Web Server (EWS) or through a Command Line Interface
(CLI). The device configuration is performed via a DB-9 RS-232 interface.
Device Front Panel
The following figure illustrates the front panel.
Figure 1:
D-Link DES-3010PA Front Panel
The device front panel is configured as follows:
•
8 Fast Ethernet ports — RJ-45 ports designated as 10/100Base-TX. The RJ-45 ports are designated as
ports 1-8.
•
DB-9 Console port — An asynchronous serial console port supporting the RS-232 electrical specification.
The port is used to connect the device to the console managing the device.
•
1000Base-T Copper port — RJ-45 ports designated as 10/100/1000Base-T. The port is designated on the
device as 9.
•
1000Base-FX port — Fiber Gigabit port designated on the device as port 10.
•
Restore Defaults Button — Resets the device. The Reset button does not extend beyond the device's front
panel surface. This it to avoid accidental device resetting.
The Power LED and the Port activity LEDs on each port of the front panel are displayed separately.
Page 10
Hide quick links:
Advertisement
Table of Contents
