Unpacking - D-Link DES-3010PA - Switch Web User Manual

Unpacking

This section contains information for unpacking the device, and includes the following topics:
•
Package Contents
•
Unpacking Essentials
Package Contents
While unpacking the device, ensure that the following items are included:
•
The device
•
Four rubber feet with adhesive backing
•
Rack kit
•
An AC power cable
•
Console RS-232 cable with DB-9 connector
•
Documentation CD
Unpacking Essentials
Note
Before unpacking the device, inspect the package and report any evidence of damage immediately.
To unpack the device perform the following:
1. It is recommended to put on an ESD wrist strap and attach the ESD clip to a metal surface to act as ground.
An ESD strap is not supplied with the device.
2. Place the container on a clean flat surface and cut all straps securing the container.
3. Open the container.
4. Carefully remove the device from the container and place it on a secure and clean surface.
5. Remove all packing material.
6. Inspect the product for damage. Report any damage immediately.
If any item is found missing or damaged, please contact your local D-Link reseller for a replacement.
Rack Installation
The device can be mounted in an EIA standard-sized, 19-inch rack, which can be placed in a wiring closet with
other equipment. To install, the device the mounting brackets must first be attached on the devices' sides.
Note
Disconnect all cables from the unit before mounting the device in a rack or cabinet.
When mounting multiple devices into a rack, mount the devices from the bottom up.
To install the device in a rack, perform the following:
Place the supplied rack-mounting bracket on one side of the device ensuring the mounting holes on the device
line up to the mounting holes on the rack mounting bracket. The following figure illustrates where to mount the
brackets.
Mounting Device
Preparing for Installation
Page 21