Setting The Default Project Options - Autodesk 24108-051400-9000 - AutoCAD Revit Architecture Suite 2008 User Manual

2 Click .
3 In the Project Files dialog box, browse to the drive on which your project is located, and click Open.
4 Click Close on the Project Browser.

Setting the Default Project Options

Use this procedure to set the default options for your AutoCAD Architecture projects.
Setting defaults saves time and helps keep data consistent across projects. The following options can be specified for
projects:
Default project location search paths
Default construct template
Default element template
Default general view template
Default detail view template
Default section/elevation view template
Default sheet set template
Default project bulletin board
Default project image
NOTE When you create a new project based on a template project, the default templates, bulletin board, and project image
of the template project are used in the new project. If the new project is not based on a template project, the settings defined
in the default project options are used.
1 Click Format menu
2 Click the AEC Project Defaults tab.
3 To add a project location search path or change an existing one, expand AEC Project Location Search Path
and do any of the following:
If you want to
change an existing project location search
path
Options.
Then
click the path you want to change, and click Browse. In the Browse for Folder
dialog box, select the new search path, and click OK.
Setting the Default Project Options | 161