Cutting Film With The Built-In Cutter; Printing Trim Lines - Epson STYLUS Pro WT7900 User Manual

56 | Using Film and Other Media
Note: Opening the front
cover causes printing to
stop. Do not open the
front cover while printing
is in progress, or your
print quality might be
affected.
Note: The minimum
printout length when
using Auto Cut is 16.5
inches (420 mm). For
shorter lengths, you need
to turn off Auto Cut and
cut the film as described
here.
Wait for the paper to move into position automatically, or press the
button to move the paper into position right away.
6. If you see a question on the display about paper settings, select
settings are correct, or select
to save your settings.
7. If the edge of the paper is uneven or wrinkled, press the
cut the edge.

Cutting Film with the Built-in Cutter

When you're not using the
by pressing a button after your print job is finished.
1. Before you print, press the l Paper Source button until you see the
roll (Auto Cut Off) icon on the LCD display.
2. Run your print job.
3. Press and release the
select , then press
CUT
4. If the paper cannot be cut by the built-in cutter, press the d button to
feed the paper to the manual cutting position. Then cut it manually.

Printing Trim Lines

You can print trim lines on the right edge of your pages (Auto Cut On) or
on the right and bottom edge (Auto Cut Off).
1. Press r .
Menu
2. Press r again to select the
3. Press d to select
PAGE LINE
4. Press d or u to select
A check mark appears next to the selected setting.
5. Press to exit the menu.
and then change the settings. Press
No
Auto Cut On setting, you can cut roll paper
button. When the selection menu appears,
. The paper is cut.
OK
PRINTER SETUP
, then press r.
, then press
ON OK
56
Yes
button to
menu.
to save the setting.
if the
OK