Cutting Paper Manually With The Built-In Cutter - Epson Pro 9000 Printer Manual

Caution
To avoid damaging the
printer, never move the
paper set lever while the
Operate or Pause light
is flashing.
6. Push the paper set lever all the way down, then close the roll paper
cover.
PRESS PAUSE BUTTON
If you're using Auto Cut and the edge of the paper is uneven, press
to recut the edge.
Cut/Eject
7. Press the button. The print head moves and the paper feeds into
Pause
printing position automatically.
display. (Even if you don't press
into printing position automatically after 10 seconds.)

Cutting Paper Manually with the Built-in Cutter

When you're not using the
manually after your print job is finished. If you're printing on canvas, vinyl,
or other heavy media, you should use scissors or a utility cutter rather than
the built-in cutter. See page 1-14 for instructions. Follow these steps to cut
manually with the built-in cutter:
1. If the paper is not positioned correctly, press one of the
buttons to adjust the paper position. Normally, you don't need to do
this after a print job is finished.
2. Press the
Paper Source
3. Press the
Cut/Eject
1-13
Handling Paper and Other Media
appears on the control panel display.
appears on the control panel
READY
, the paper and printer will move
Pause
setting, you need to cut the paper
Auto Cut
button until the
Roll Auto Cut
button. The paper is cut.
| 1-13
Paper Feed
light comes on.