|
Loading paper in the printer
6
Loading paper in the printer
See the Setup guide for instructions on placing and loading roll paper in the printer.
Cutting paper manually with the built-in cutter
When Auto Cut is set to Off, you can cut roll paper manually after your print job is finished by pressing
the
button.
Note: The built-in cutter may not be able to cut some types of media. Heavy or thick media types may dull the
cutter.
Before you print, press the r
1.
Press the d button to select
2.
Press the d button to select
3.
Press the r button to select
4.
Press the d or u buttons to select
5.
Press the
button to save the setting. A check mark appears next to Off.
OK
6.
Press the
button to exit the menu.
7.
Run your print job.
8.
Press and release the
9.
If the paper cannot be cut by the built-in cutter, press the d button to feed the paper to the manual
10.
cutting position. Then cut it manually.
Printing trim lines
When Auto Cut is set to Off, you can print a trim line (page line) between print jobs as a guide for manual
cutting.
Press the r
Menu
1.
Press the d button to select
2.
Press the d button to select
3.
button.
Menu
, then press the r button.
Paper
Roll Paper Setup
.
Auto Cut
.
Off
button to cut the paper.
button.
, then press the r button.
Paper
Roll Paper Setup
, then press the r button.
, then press the r button.