Setting Up The Printer; Unpacking And Assembling The Printer - Epson STYLUS Pro WT7900 User Manual

Chapter 1:
Setting Up
the Printer
WARNING: Four people are
required to unpack and set
up the printer.
Note: When choosing a
place for the printer, leave
adequate room for easy
access and ventilation.
Avoid locations subject to
direct sunlight, excessive
heat, moisture, or dust.
Also avoid locations near
potential sources of
electromagnetic
interference, such as
loudspeakers, cordless
phones, TVs, or air
conditioners.
This chapter includes the following information:
Unpacking and assembling the Epson Stylus Pro WT7900
•
Connecting the power cord
•
Installing ink
•
Connecting to your computer and a network
•
Installing the printer software
•
Updating the printer firmware
•
Configuring the printer for a network
•

Unpacking and Assembling the Printer

Before you begin, make sure you have sufficient space to set up and use the
printer—at least 12 inches (300 mm) on all sides in addition to these
dimensions:
53 × 26 inches (1356 × 667 mm) without the film basket installed
•
53 × 57 inches (1356 × 1442 mm) with the film basket installed
•
For assembly, you need floor space of approximately 8 × 8 feet (2.4 × 2.4 m)
for the printer and stand.
17
17