Epson STYLUS Pro WT7900 User Manual page 93

Note: The CUSTOM
setting in maintenance
mode is not normally
used.
Maintaining and Transporting the Printer
3. Use the d and u buttons to select the settings described below. If you
need to back up to the previous menu level, press l.
To change the language on the LCD display, press d to highlight
•
LANGUAGE
want, then press
mode and returns to normal operation.
To change the units of measurement, press d to highlight
•
, then press r. Press d to switch from
UNITS
, then press
FEET/INCH
To change the temperature units of measurement, press d to
•
highlight
TEMPERATURE UNITS
from (Celsius or centigrade) to
C
select it. Press
To change the maximum roll paper tension, press d to highlight
•
ROLL PAPER TENSION
maximum value, or u to increase it (from 1 to 5). The default
setting is 3. Press
To run a super strong cleaning cycle, press d to highlight
•
SS CLEANING
start the cleaning cycle.
To return all control panel settings to their default values, press d to
•
highlight
DEFAULT PANEL
Press to restore the default settings.
OK
To change the number of times the printer cleans the print head
•
after it performs a nozzle check and finds blocked nozzles, press d
to highlight
AUTO CLEANING TIMES
to change the setting (from 1 to 3), then press
setting. The default setting is 1 (recommended).
4. To exit maintenance mode, turn off the printer by pressing the P power
button. Press the P power button again to turn on the printer in the
normal operating mode.
, then press r. Press d until you see the language you
to select it. The printer exits maintenance
OK
to select it. Press
OK
F
when done.
l
, then press r. Press d to decrease the
to select the setting you want.
OK
, then press r to display
, then press r to display
93
to
METRIC
when done.
l
, then press r. Press d to switch
(Fahrenheit), then press
. Press
EXECUTE
EXECUTE.
, then press r. Press u to d
to save the
OK
| 93
LENGTH
to
OK
to
OK