Customizing The Settings For Your Paper; Creating Custom Paper Settings - Epson STYLUS Pro WT7900 User Manual

Note: Paper
configurations are needed
only for non-Epson media.
Note: You can also create
paper configurations using
the Epson LFP Remote
Panel installed from the
printer software CD.

Customizing the Settings for Your Paper

When you choose a media type in your Epson printer software, the driver
automatically determines the best settings for your paper. However, you may
want to fine-tune how the printer handles various media—especially if you
use non-Epson paper or a paper not supported by the driver. Use the paper
configuration settings described below.
You can create a group of settings for each paper type (up to ten types) and
select the settings whenever you print on a particular stock.

Creating Custom Paper Settings

To create settings a specific paper type, make sure the paper you want to use
is loaded in the printer. Then follow these steps:
1. Press r , then press u or d to select
Menu
2. Press r, then press d to select
3. Press r, then press d or u to select a number (1 to 10). Press r to save
the number setting.
4. Press d or u to select
select a media type, then press r. Press
5. Press l twice to go back to the previous menu.
6. Press d or u to select
to select
NARROW
setting is recommended for most paper types. Press
setting, then press l to go back to the previous menu.
7. Press d or u to select
to print the paper thickness pattern. A pattern similar to the following is
printed:
1 2 3 4
Smallest gap
Using Film and Other Media
CUSTOM PAPER
, then press r. Press d or u to
PAPER TYPE
OK
, then press r. Press the d button
PLATEN GAP
, ,
STANDARD WIDE
THICKNESS PATTERN,
5 6 7 8 9 10
73
.
PAPER SETUP
.
to save it.
, or . The
WIDER STANDARD
to save the
OK
then press r. Press
11 12 13 14 15
| 73
OK