Automatically Setting The Printer's Ip Address; Dynamic Methods Of Setting The Printer's Ip Address - Epson AcuLaser CX29NF User Manual

Automatically Setting the Printer's IP Address

If the printer is connected to a small established TCP/IP network without a DHCP server, use the
installer on the Software Disc to detect or assign an IP address to your printer. For further
instructions, insert the Software Disc into your computer's CD/DVD drive. After the Installer
launches, follow the prompts for installation.
Note:
For the automatic installer to function, the printer must be connected to an established TCP/IP network.

Dynamic Methods of Setting the Printer's IP Address

There are two protocols available for dynamically setting the printer's IP address:
❏ DHCP (enabled by default)
❏ AutoIP
You can turn on/off both protocols using the operator panel, or use EpsonNet Config to turn on/off
DHCP.
Note:
You can print a report that includes the printer's IP address. On the operator panel, press the System
button, select Report/List, press the
button. The IP address is listed on the System Settings page.
Using the Operator Panel
To turn on/off either the DHCP or AutoIP protocol:
1. On the operator panel, press the System button.
2. Select Admin Menu, and then press the
3. Select Wired Network, and then press the
4. Select TCP/IP, and then press the
5. Select IPv4, and then press the
6. Select Get IP Address, and then press the
Epson AcuLaser CX29 Series
button, select System Settings, and then press the
button.
button.
button.
button.
button.
User's Guide
Network Basics 61