Epson AcuLaser CX29NF User Manual page 254

Select a high value if your printer is in constant use. In most circumstances, this keeps the printer ready
to operate with minimum warm-up time. Select a value between 5 and 30 minutes for power saver
mode if you want a balance between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the power saver mode when it receives
data from the computer or remote fax machine. You can also change the status of the printer to the
standby mode by pressing the Energy Saver button on the operator panel.
Power Saver Wake Up
Purpose:
To specify whether to wake up from the Low Power or Sleep mode when OnHook is set to Off.
Values:
OffHook Wake
Up
Auto Reset
Purpose:
To automatically reset the settings for Copy, Scan, or Fax to the default settings and return to the
standby mode after you do not specify any settings for the specified time.
Values:
45sec*
1min
2min
3min
4min
Fault Time-out
Purpose:
To specify the amount of time the printer waits before canceling a job that stops abnormally. The print
job is cancelled if the time-out time is exceeded.
Off* Does not wake up from the Low Power or Sleep mode when OnHook is set to
Off.
On Wakes up from the Low Power or Sleep mode when OnHook is set to Off.
Epson AcuLaser CX29 Series
Using the Operator Panel Menus and Keypad
User's Guide
254