HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 168

Error Messages
Table 9: Embedded Web Server Messages (Continued)
Error 157: Access Control
List is Disabled
Error 158: Invalid IP
Access Control List Pair
Error 159: Invalid IP
Access Control List Pairs
Count Value
Error 160: Management
Client IP Not Included In
IP Access Control List
Error 161: SANtegrity
Authentication feature key
must be uninstalled
Error 162: List is full
Error 163: FICON MS
feature key must be
installed
Error 164: FICON CUP
Zoning feature key must
be uninstalled
Error 165: CUP Zoning
feature key must be
installed
Error 166: CUP Zoning
feature must be enabled
Error 167: Diagnostics
can not be run on inactive
port
168
Message
The switch must be offline
and Fabric Binding must
be inactive before this
feature can be disabled.
The pair of IP addresses
are invalid and cannot be
added to the list.
The list being activated
has an invalid number of
IP pairs.
The management
interface IP address is not
in the list.
The operation cannot be
completed with the
SANtegrity Authentication
key installed.
There is no more room for
new entries in the list.
The command is not
available without the
FICON MS feature key.
The operation cannot be
completed with the
FICON CUP Zoning key
installed.
The command is not
available without the
FICON CUP Zoning
feature key
The command cannot be
completed with the CUP
Zoning feature enabled
The port is in the inactive
state and diagnostics
can't be run.
Description
Embedded Web Server User Guide
Action
Deactivating this feature
can be disruptive to
Fabric operations. Take
the switch offline and
deactivate fabric binding
before disabling this
feature.
Make sure the IP
addresses are valid and
the first IP is lower than
the second
Make sure there is at least
one IP address in the
Access Control List.
The management IP must
be in the list or the current
connection would be lost.
Remove the SANtegrity
Authentication feature
key.
Remove a different entry
and try again.
Install the FICON MS
feature key.
Remove the FICON CUP
Zoning feature key.
Install the FICON CUP
zoning feature key.
Enable FICON CUP
Zoning.
The port state must
change out of the inactive
state.