HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 167

Table 9: Embedded Web Server Messages (Continued)
Error 152: Invalid FICON
Management Server State
Error 153: Feature Key
Not Installed
Error 154: Invalid
Membership List WWN
Error 155: Cannot
Remove Active Member
From List
Error 156: Cannot
Disable Fabric Binding
while Switch is Online
Embedded Web Server User Guide
Message
The request cannot be
completed because the
FICON MS state
submitted is invalid.
The request cannot be
completed because the
required feature key has
not been installed to the
firmware.
The request cannot be
completed because the
WWN does not exist in
the switch binding
membership list.
This member cannot be
removed from the fabric
security list because it is
currently logged in.
The switch must be offline
and fabric binding must
be inactive before this
feature can be disabled.
Description
Error Messages
Action
The FICON MS state may
be set to either enable or
disable.
Contact your sales
representative.
Make sure that the WWN
deleted matches the
WWN in the switch
membership list. Make
appropriate changes and
resubmit the request.
Fabric security rules
prohibit any device or
switch from being
isolated from the fabric
via a membership list
change. If it is truly the
intention of the user to
remove the device in
question from the
membership list, then
there are several
approaches to take. This
request may be
completed most
non-disruptively by
blocking the port (or
physically removing the
device from the managed
switch) to which this
device is attached and
resubmitting the request.
Deactivating this feature
can be disruptive to
Fabric operations. Take
the switch offline and
deactivate fabric binding
before disabling this
feature.
167