HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 163

Table 9: Embedded Web Server Messages (Continued)
Error 106: Invalid
Threshold Scope
Error 107: Invalid
Threshold State
Error 108: Invalid TTA
Type
Error 109: Invalid CTA
Type
Error 110: Invalid Percent
Utilization
Error 111: Invalid
Threshold Type
Error 112: No Threshold
Definition Given
Error 115: Invalid Switch
Speed
Error 116: Switch Not
Capable of 2 Gb/sec
Embedded Web Server User Guide
Message
The scope of a threshold
alert is not set to a valid
state before the user
activates an alert.
The scope of a threshold
alert must be set before
the user activates an alert.
The type of the throughput
threshold alert (TTA) has
not been set.
The type of the counter
threshold alert has not
been set.
The type of the throughput
threshold alert has not
been set.
The type of the threshold
alert is not valid.
The threshold value for
the alert was not
configured before the user
attempted to activate the
alert.
The request cannot be
completed because the
switch is not capable of
operating at the
configured speed.
The request cannot be
completed because the
switch is not capable of
operating at 2 Gb/s.
Description
Error Messages
Action
Set the scope of the
threshold alert, then try to
activate the alert.
Set the scope of the
threshold alert, then try to
activate the alert.
Set the type of the TTA,
then try to activate the
alert.
Set the type of the CTA,
then try to activate the
alert.
Set the type of the TTA,
then try to activate the
alert.
Configure the type of the
throughput threshold alert
to one of the types found
in the enumerated table
for TTAs.
Set the threshold value,
then try to activate the
alert.
Consult the
installation/service
manual to determine the
speed capabilities of your
product.
Consult the
installation/service
manual to determine the
speed capabilities of your
product.
163