HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 109

Fw v06.xx/hafm sw v08.02.00 hp storageworks embedded web server user guide (aa-rtdrc-te, july 2004)
Hide thumbs Also See for 316095-B21 - StorageWorks Edge Switch 2/24:
Table of Contents

Advertisement

Note:
management style parameter of the HAFM interface. The S/390 mode used for the
EWS interface is equivalent to the FICON management style on the HAFM. The EWS
term Open Systems mode is equivalent to Open Systems management style for the
HAFM.
Embedded Web Server User Guide
Preferred Domain ID — The ID to be used if the product participates in a
multiswitch fabric. The preferred domain ID must be unique for each director
and switch in a fabric.
Active Domain ID — The domain ID assigned to the switch.
FC Address Domain ID — The value of the domain byte of the Fibre
Channel address for ports on this product.
Insistent Domain ID — Indicates whether the domain ID is enabled to be
insistent. This option is required if Enterprise Fabric Mode (an optional
SANtegrity Binding feature) is enabled.
Rerouting Delay — Indicates whether rerouting delay is enabled. Enabling
the rerouting delay ensures that frames are delivered in order through the
fabric to their destination.
Domain RSCN — Domain Register For State Change Notifications (domain
RSCNs) are sent between end devices in a fabric to provide additional
connection information to host bus adapters (HBA) and storage devices. This
option is required if Enterprise Fabric mode (an optional SANtegrity feature)
is enabled.
Suppress RSCN on Zone Set Activiations — If enabled, registered state
change notification (RSCN) messages are prohibited from being sent to ports
on the switch following any change to the fabric's active zone set. If the state
shown is disabled, RSCN messages are sent to ports on the switch for changes
to the fabric's active zone set.
Operating Mode — Indicates whether the operation mode is S/390 mode or
Open Systems mode. (S/390 mode is not supported with the
Edge Switch 2/24.)
The operation mode parameter of the EWS interface is equivalent to the
Director Speed — speed of communications on the product. Values can be
1 Gb/s or 2 Gb/s. Valid on the Director 2/64 only.
Viewing Product and Fabric Data
109

Advertisement

Table of Contents
loading

Table of Contents