IBM 8863 - eServer xSeries 366 Service Manual page 132

10. Repeat steps 5 through 9 to replace any remaining DIMMs on the memory
11. Replace the memory card:
Hot-adding memory modules: To hot-add memory modules and memory cards,
complete the following steps:
116
IBM xSeries 366 Type 8863: Problem Determination and Service Guide
DIMM
8. Insert the DIMM into the connector by aligning the edges of the DIMM with the
slots at the ends of the DIMM connector.
9. Firmly press one end of the DIMM into the connector; then, press the other
end into the connector. The retaining clips snap into the locked position when
the DIMM is seated in the connector. If there is a gap between the DIMM and
the retaining clips, the DIMM has not been correctly inserted; open the
retaining clips, remove the DIMM, and then reinsert it.
card.
a. Insert the memory card into the memory card connector.
b. Press the memory card into the connector and close the retention levers.
1. Read the safety information that begins on page vii, and "Handling
static-sensitive devices" on page 100.
Attention: Static electricity that is released to internal server components
when the server is powered-on might cause the server to halt, which could
result in the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when working
inside the server with the power on.
2. Remove the top cover "Removing the cover and bezel" on page 101.
Attention: When moving the memory card, do not allow it to impact any
components or structures inside the server.
3. Place a memory card on a flat, static protected surface with the DIMM
connectors facing up.
Attention: To avoid breaking the DIMM retaining clips or damaging the
DIMM connectors, open and close the clips gently.
4. Open the retaining clip on each end of the DIMM connector.
Retaining
clip