IBM 8863 - eServer xSeries 366 Service Manual page 101

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, "Parts listing, Type 8863," on page 93 to determine which components are customer
replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)", that step must be performed only by a
trained service technician.
System-error log message
Memory Card x removed
Multiple fan failures
OS Watchdog Triggered
PCI-X Card Power Good Fault
POST Watchdog Triggered
Power Good Fault detected by memory card.
Power Supply Temperature Warning
Power supply current exceeded max spec value 1. Install another power supply (if possible) and make sure that ac
Power Supply X 12V Over Current Fault
Action
Information only; if the message persists:
Note: Make sure you re-enable the memory in the
Configuration/Setup Utility program. See, "Memory problems" on
page 40
1. Make sure that the memory card lever is securely latched.
2. Reseat the memory card.
Replace any missing or failed fans or power supplies.
1. Reconfigure the O/S watchdog timer to be a higher value.
2. Reinstall the Remote Supervisor Adapter II SlimLine device
driver for the operating system.
3. Disable the O/S watchdog.
4. Check the integrity of the installed operating system.
5. Reinstall the operating system with applicable device drivers.
1. Reseat the Remote Supervisor Adapter II SlimLine, if present.
2. Reseat the I/O board.
3. Replace the I/O board.
4. (Trained service technician only) Replace the PCI-X board.
1. Reconfigure the POST watchdog timer to be a higher value
(consistent with the time it takes to complete POST).
2. Disable the POST watchdog.
1. Reseat the memory cards.
2. Reseat the DIMMs.
3. Reseat the microprocessor tray.
4. (Trained service technician only) Replace the power backplane.
5. (Trained service technician only) Replace the microprocessor
tray.
1. Make sure that the power supply fans have good airflow and
are not obstructed.
2. Make sure the room temperature is within the recommended
range (see "Environment" at "Features and specifications" on
page 3).
3. Replace the power supply.
power cords are correctly connected.
2. Remove devices that consume an extraordinary amount of
power.
3. Replace the power backplane.
1. Power supply
2. Power backplane
85
Chapter 2. Diagnostics