Tier 1 Cru Information; Battery - IBM 8863 - eServer xSeries 366 Service Manual

4. Lift the cover-release latch. The cover slides to the rear approximately 13 mm
5. Press on the bezel retention tabs at the top edge of the bezel, and pull the top
6. Lift the bezel up to release the tabs at the bottom edge of the bezel.

Tier 1 CRU information

Installation of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at your
request, you will be charged for the installation.

Battery

The following notes describe information that you must consider when replacing the
battery in the server.
v When replacing the battery, you must replace it with a lithium battery of the same
v To order replacement batteries, call 1-800-772-2227 within the United States, and
v After you replace the battery, you must reconfigure the system and reset the
v To avoid possible danger, read and follow the following safety statement.
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Complete the following steps to replace the battery:
102
IBM xSeries 366 Type 8863: Problem Determination and Service Guide
(0.5 inch). Lift the cover off the server.
Attention: For proper cooling and airflow, replace the top cover before turning
on the server. Operating the server for more than 2 minutes with the top cover
removed might damage server components.
of the bezel slightly away from the server.
type from the same manufacturer.
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, call your IBM reseller or IBM marketing representative.
system date and time.
1. Read the safety information that begins on page vii, and "Handling
static-sensitive devices" on page 100, and follow any special handling and
installation instructions supplied with the replacement battery.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables necessary to replace the device.