Table of Contents
Advertisement
Altos R5250 Installation Configuration Guide
After you the system boot into text mode, copy the ATI driver installer to
4.
HDD.
Go to the directory that includes the ATI driver installer and run the ATI
5.
driver installer
# ./ati-driver-installer-8.35.5-x86.x86_64.run
Follow the instructions and use the default settings to install the driver.
6.
After the driver is installed, run "aticonfig --initial" to configure the
7.
driver.
# aticonfig –-initial
Uninitialised file found, Configuring.
Using /etc/X11/xorg.conf
Save back-up to /etc/X11/xorg.conf.original-0
Please reboot the system.
8.
If you want to change the display setting, please DO NOT use the OS
9.
built-in utility. Please launch the ATI Catalyst Control Center by using
"amdcccle".
# amdcccle
Gigabit Ethernet Driver Installation
1.
You can find the onboard NVIDIA nForce Networking Controller driver in
EasyBUILD 8.0 build 100. Please refer to Directory on EasyBUILD in Driver
Required section.
2.
After you insert the EasyBUILD 8.0 build 100 into the optical drive, it will
be mounted automatically. Please copy the driver from the EasyBUILD 8.0
build 100 to HDD first.
# cp –R /media/EBV71B600/Disk/R5250/nic/Nvidia/sles10/. /tmp
3.
Install the driver
# cd /tmp
# rpm –ivh nvlan-sles10-0.62-1.23.i686.rpm
RAID Utility Installation
You can find the MegaRAID Storage Manager in EasyBUILD 8.0 build 100.
1.
Please refer to Directory on EasyBUILD in Software Required section.
After you insert the EasyBUILD 8.0 build 100 into the optical drive, it will
2.
be mounted automatically. Please copy the MegaRAID Storage Manager
from the EasyBUILD 8.0 build 100 to HDD first.
# cp –R /media/
106
EBV71B600
/app/R5250/SAS/LSI1068/Linux/. /tmp
Advertisement
Table of Contents
