Driver Installation - Acer Altos G300 Series User Manual

90
4 Select SCSI Adapters.
5 Select the Drivers tab.
6 If the IDE Software RAID is already enabled, it will appear in the list as "LSI
CSB6 Controller." Select and remove it by clicking the Remove button.
7 Click the Add button.
8 Click the Have Disk button. Insert the floppy diskette into the floppy drive.
9 Select Drive A: and click OK.
10 Select LSI CSB6 Controller and click OK.
11 After Windows copies the driver, reset the system.
Confirming the Windows NT 4.0 or Windows

2000 Driver Installation

Use the following procedure to confirm that the IDE Software RAID
Windows NT 4.0 or IDE Software RAID Windows 2000 driver is properly
installed.
Step Description
1 Click on the Windows Start button. The Windows menu is displayed.
2 Select Settings.
3 Click on Control Panel.
4 Select SCSI Adapters.
5 Select the Drivers tab.
If the RAID board is installed, it will appear in the list as "LSI CSB6
Controller."
6 Select the Devices tab.
If drives are connected to IDE Software RAID and configured properly, you
will see one or more entries as LSI CSB6 #xx under LSI CSB6 Controller.
5 Configuring IDE Software RAID