Table of Contents
Advertisement
required partitions and how to convert Device Name into Device ID.
NOTE: Normally, a file system to mount is identified in /etc/fstab by the Device
Name. This identification can be changed so the file system to mount is found
by searching for a Device ID or Volume label.
At Installation Setting, Click Partitioning .
8.
Select Create Custom Partition Setup option box, and click Next
9.
Select Custom Partitioning (for experts) option box, and then click Next
10.
To create a partition, click Create at the bottom and then select Primary
11.
Partition option box.
In creating the "/boot" partition, you need to fill in the 'Mount Point'
12.
with "/boot". In addition, you will need to enter the size of the partition.
Set it to '+1GB' which is plenty. Then click the tab Fstab Option.
You will see Device Name is the default option in the section labeled
13.
'Mount in /etc/fstab by'. Then change the Fstab options to Device ID and
click OK at the bottom.
In creating the "swap" partition, please follow step described in step11 –
14.
step13. For the "swap" partition, you need to change File system from
'Reiser' to 'Swap' in the combo box. And don't forget to fill in the 'Mount
Point' with "swap". The typical size of the partition is '+1GB'.
In creating a root "/" partition, please follow step described in step11 –
15.
step13 and to fill in the 'Mount Point' with "/". Typitically, assign rest of
available driver space for the root partition "/".
Once all the partitions are created, click Finish to proceed with normal
16.
installation.
If you have installed the ATI FireGL V5200 in the system, you need to
17.
install addition packages during the OS installation. If you are using
onboard XGI Z9s, please go to step 13 directly.
At Installation Setting, select the Software.
18.
Check C/C++ Compiler and Tools under Development to add C/C++
19.
compiler tools.
Click on Details, change the Filter from Patterns to Package Groups.
20.
Select the Source under Development in left window and check kernel-
21.
source in the right window to add the kernel source.
Click on Accept and continue the installation.
22.
Follow the instruction to complete the installation.
23.
If you have installed the ATI FireGL V5200 in the system, the system
24.
CANNOT boot into X-window after OS installation completed. You need
113
Altos R5250 Installation Configuration Guide
Advertisement
Table of Contents
