Table of Contents
Advertisement
Note: You might need a screwdriver to turn the thumbscrews.
14. Grasp the metal flange (in the center of the assembly between the power
backplane and the I/O board) and gently pull the assembly slightly toward the
front of the server so that the two notches on each side of the assembly align
with the two metal loops on each side of the chassis.
15. Grasp the cable tie and gently lift up the rear of the assembly; then, slide the
front end of the assembly toward the rear of the server and lift it out of the
chassis.
Attention:
When moving the assembly, do not allow it to impact any
components or structures inside the server.
Flange
Cable tie
Chapter 5. FRU information (service only)
AC
AC
1
Captive
thumb screws
83
Advertisement
Table of Contents
