Table of Contents
Advertisement
11. Reinstall the screw that was removed in step 4 on page 72.
12. Verify that the assembly opens and closes smoothly.
13. Close and latch the operator information panel.
14. Connect the cable to the media interposer card.
15. Replace the bezel and top cover.
16. Reconnect external cables and power cords.
Media interposer card
This section contains information about removing and replacing the media
interposer card.
Note:
Complete the following steps to remove the media interposer card:
1. Turn off the server and all peripheral devices; then, disconnect all power cords
2. Remove the top cover (see "Removing the cover and bezel" on page 32).
3. Pull the CD-ROM drive or DVD-ROM drive out of the server slightly to
4. Disconnect all cables from the media interposer card.
5. Pull out the two blue push pins.
shoulder screw on the bottom of the assembly will slide into and along the
curved channel. This allows the panel to swing out.
v Read "Installation guidelines" on page 29.
v Read "Safety information" on page 147.
v Read "Handling static-sensitive devices" on page 30.
and external cables.
disengage it from the media interposer card.
Pushpins
Chapter 5. FRU information (service only)
73
Advertisement
Table of Contents
