Table of Contents
Advertisement
Complete the following steps to install a hot-swap power supply:
1. Read "Safety information" on page 147 and "Installation guidelines" on page 29.
2. Remove the cover (see "Removing the cover and bezel" on page 32).
3. If you are adding a power supply to an empty power bay, remove the cover
4. If you are replacing a failed power supply, remove the failed power supply from
5. Raise the power supply handle to the open position.
6. Place the new power supply into the power bay in the chassis and fully close
7. Connect one end of the power cord for the new power supply into the connector
8. Make sure that the ac power LED on the rear of the power supply and the ac
9. Continue with "Completing the installation" on page 58.
52
IBM xSeries 365 Types 8861, 8862: Hardware Maintenance Manual and Troubleshooting Guide
Locking handle
(open)
from the ac power connector opening on the rear of the server.
the bay.
a. Unplug the power cord from the connector on the back of the failed power
supply.
b. Press the locking latch on the power supply handle and move the locking
handle to the open position.
c. Lift the failed power supply out of the bay.
the locking handle.
on the back of the power supply; route the power cord through the
cable-management arm and connect the other end of the power cord into a
properly grounded electrical outlet.
power LED on the top of the power supply are lit, indicating that the power
supply is operating correctly. If the server is turned on, make sure that the dc
power LED on the top of the power supply is lit also.
Locking latch
Power supply 2 (PS2)
AC power connector
cover
Power supply 1 (PS1)
AC
DC
AC power
LED (green)
DC power
LED (green)
Fan LED
(amber)
Advertisement
Table of Contents
