Table of Contents
Advertisement
16-DIMM memory board
When you restart the server after adding or removing a pair or quad of DIMMs, the
server displays a message that the memory configuration has changed.
DIMM installation
Complete the following steps to install DIMMs:
Note: Depending on the model, the memory cassette in your server might not have
1. Read "Safety information" on page 147, "Installation guidelines" on page 29, and
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Open the two DIMM access doors on the top of the memory cassette.
Bank 1
Bank 3
Bank 4
Bank 2
Port 2
doors; this is normal. If the memory cassette has no doors, disregard any
instructions to open or close the doors.
the documentation that comes with the DIMMs.
all external cables. Remove the top cover (see "Removing the cover and bezel"
on page 32).
Bank 5
Bank 7
Bank 8
Bank 6
Port 1
Chapter 4. Installing options
41
Advertisement
Table of Contents
