Table of Contents
Advertisement
PCI or PCI-X adapters
The following notes describe the types of adapters that your server supports and
other information that you must consider when installing a PCI or PCI-X adapter:
v The server supports 3.3 V and universal PCI and PCI-X adapters; it does not
v The following illustration shows the location and bus speeds of the PCI-X
v Each PCI/PCI-X slot is on a separate PCI bus.
v Slot 1 is a PCI slot and is dedicated to the Remote Supervisor Adapter II. The
v For slots 2 through 6, the bus speed will be set to the speed of the adapter; if a
v If you install a ServeRAID 6i adapter, it must be installed in slot 2.
v If you install an IXA adapter, it must be installed in slot 3.
v Locate the documentation that comes with the adapter and follow those
support 5.0-V-only adapters.
expansion slots on the I/O board.
Note: The illustrations in this document might differ slightly from your hardware.
Attention LED
Power LED
PCI slot 1
33 MHz 64-bit
PCI-X slot 2
100 MHz 64-bit
PCI-X slot 3
133 MHz 64-bit
PCI-X slot 4
133 MHz 64-bit
PCI-X slot 5
133 MHz 64-bit
PCI-X slot 6
133 MHz 64-bit
Slot number
PCI Bus
1
0
2
3
3
6
4
F (15)
5
C (12)
6
9
adapter will operate in PCI mode only. The bus speed is 33 MHz only. The
adapter is non-hot-swappable; turn off the server when removing and installing
the adapter.
PCI adapter is installed, the bus will run in PCI mode.
instructions in addition to the instructions in this chapter.
SCSI internal
cable connector (J17)
Chapter 4. Installing options
33
Advertisement
Table of Contents
