IBM 8862 - Eserver xSeries 365 Maintenance And Troubleshooting Manual page 126

Note: See Chapter 7, "Parts listing, Types 8861, 8862," on page 139 to determine which components are
replaceable by the customer and which components must be replaced by an IBM field service technician.
Service Processor/RXE-100 message
PCI Expansion Unit X Side A or B: +1.8v over
voltage
PCI Expansion Unit X Side A or B: +1.8V
Power Not Adequate
PCI Expansion Unit X Side A or B: +1.8v
under recommended voltage
PCI Expansion Unit X Side A or B: +1.8v
under voltage
PCI Expansion Unit X Side A or B: +12V A
Bus Fault
PCI Expansion Unit X Side A or B: +12V B
Bus Fault
PCI Expansion Unit X Side A or B: +12V C
Bus Fault
PCI Expansion Unit X Side A or B: +12V D
Bus Fault
PCI Expansion Unit X Side A or B: +12v over
recommended voltage
PCI Expansion Unit X Side A or B: +12v over
voltage
PCI Expansion Unit X Side A or B: +12v
under recommended voltage
PCI Expansion Unit X Side A or B: +12v
under voltage
PCI Expansion Unit X Side A or B: +2.5V
Branch-A Power Not Adequate
PCI Expansion Unit X Side A or B: +2.5V
Branch-B Power Not Adequate
PCI Expansion Unit X Side A or B: +2.5v over
recommended voltage
116
IBM xSeries 365 Types 8861, 8862: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
v Replace board as indicated.
v Replace board as indicated.
1. Check for shorts on boards.
2. Replace board as indicated.
1. Check for shorts on boards.
2. Replace board as indicated.
1. Check all slots.
2. Replace Board A
3. Replace DMC card.
4. Power backplane.
5. Power supply.
1. Check all slots.
2. Replace Board B.
3. Replace DMC card.
4. Power backplane
5. Power supply
1. Replace fans one at a time until error clears.
2. Replace DMC card.
3. Power backplane
4. Power supply
1. DMC card.
2. Power backplane
3. Power supply
v Power supply.
v Power supply.
1. Check adapters for shorts.
2. Check pins.
3. Power supply
1. Check adapters for shorts.
2. Check pins.
3. Power supply.
v Remove adapters one at a time.
v Remove adapters one at a time.
v Replace Board A or B as indicated.