Before You Start; Check Your Protocol; Configure Your Network Connections - Xerox 850DX - Phaser Color Solid Ink Printer User Manual

AccXES Client Tools User Guide

Before You Start

Check your protocol

Before installing the AccXES Client Tools (ACT) software, you should make
sure that you are using the TCP/IP protocol at BOTH your workstation and the
printer. (See NOTE below.) Check the protocols that are currently enabled at
your workstation.
Windows 2000/XP: Right mouse click on My Network Places. Select
Properties. Right mouse click on Local Area Connection. Select
Properties.
NT 4.0: Right mouse click on Network Neighborhood. Select
Properties, then left mouse click on the Protocols tab.
If you will be changing protocols from an existing working setup, or setting up
a new protocol, you should refer to the step-by-step setup instructions
provided in the Network Admin Guide/Controller Setup Tool available on the
Xerox website at http://www.xerox.com. (To read this document, you will
need Adobe Acrobat 3.0 software, or higher, installed on your workstation.)
NOTE: External print servers (such as the Xerox External Print Server), that
do not have bi-directional communications, are used for the submission of
print jobs only. The other AccXES Client Tools features, such as job
accounting, the printer queue, and document retrieval will not function. These
print servers are recommended for support of non-TCP/IP networking
environments only.

Configure Your Network Connections

At the printer user interface, or Web PMT, check that the Subnet Mask, IP
Address, and Gateway settings are correct. These are needed so that your
workstation will be able to communicate with your AccXES compliant scanner
and printer.
On the Web PMT select Printer Defaults > Network > TCP/IP.
On the printer user interface select Setup IO Ports > Ethernet TCP/IP >
TCP/IP Address, Gateway, and Mask.
10