Tandberg Data MSERIES FC USER User Manual page 9

Set network properties and specify an IP address for the computer.
3
Right-click the network icon on the computer's desktop.
a
For some versions of Windows, this icon may be labeled
Network Neighborhood
icon may be labeled
When the pop-up menu appears, select
b
dialog box appears.
Click the
c Protocols
2000 or later) tab.
Double-click the
d
Properties dialog box appears.
Click the
e Specify an IP address
Subnet Mask, and Gateway fields become active.
Type (where x is a number between 2 and 253) in the IP
f 10.0.0.x
Address field,
255.255.255.0
nothing in the Gateway field.
Click until you completely exit all dialog boxes.
g OK
For Windows NT users, open a DOS window and type
h
ipconfig/release <Enter>
(For other versions of Windows, this step is not required.)
Turn on the library.
4
Establish a Telnet connection to the FC420 Fibre bridge. To do this:
5
Start a Telnet session from the computer desktop by selecting
a
.
Start > Run
In the Run dialog box, type
b
The Telnet window appears (as shown in
connection with the FC420 Fibre bridge. When you see the
prompt, command line mode is available.
Configuring FC420 Firmware
Tandberg Data FC420 Bridge Option User's Guide
Document T6423053-01, Ver. 1, Rel. 0
. For other versions of Windows, the
My Network Places
(Windows NT) or
Connections
menu item. The TCP/IP
TCP/IP Protocol
option button. The IP Address,
in the Subnet Mask field, and
followed by
ipconfig/renew <Enter>
telnet 10.0.0.1
figure
November 2002
or something similar.
. A Network
Properties
(Windows
.
and then click .
OK
5), indicating a
Ready
9