Tandberg Data MSERIES FC USER User Manual page 17

Command
FcFairArb
FcFullDuplex
FcHard
FcHardAddress
FcInitiator
FcPortList
(Immediate)
Fcp2
Fcp2Conf
Fcp2CRN
FcSCSIBusyStatus
FcTargets (Immediate)
Description
Turns on or off the FC-AL arbitration
fairness. Applies to all three Fibre
Channel ports on each board.
Enables/disables full duplex
communication between the Fibre
bridge and other Fibre Channel
devices.
Enables/disables Fibre Channel hard
address assignment. Under soft
addressing the FC420 loop address is
assigned during loop initialization.
Sets/displays the value used as the FC-
AL hard address.
Enables/disables the initiator function
of the Fibre bridge on the Fibre
Channel network.
Lists the available Fibre Channel ports
and their current status.
Enables/disables the Fibre bridge's
compliance with the FCP-2 Fibre
Channel specification.
Enables/disables the Fibre bridge's
capability to request FCP_CONF IUs.
This option is only valid when the fcp2
command is also enabled.
Enables/disables the Fibre bridge's
capability to accept CRNs for precise
delivery of SCSI commands. This
option is only valid when the fcp2
command is also enabled.
Specify the SCSI status value returned
when the FC420 is unable to accept a
SCSI command due to a temporary
lack of internal resources.
Provides the node name, Fibre LUN,
and inquiry data for every Fibre
Channel target device visible to a Fibre
bridge operating in initiator mode.
FC420 Services Software Commands
Tandberg Data FC420 Bridge Option User's Guide
Document T6423053-01, Ver. 1, Rel. 0
Default Syntax
enabled set fcfairarb [enabled |
disabled]
get fcfairarb
enabled set fcfullduplex [enabled |
disabled]
get fcfullduplex
disabled set fchard [enabled |
disabled]
get fchard
FC port 0 set fchardaddress [fp [address]]
0x03
get fchardaddress [fp]
disabled set fcinitiator [enabled |
disabled]
get fcinitiator
fcportlist
disabled set fcp2 [enabled | disabled]
get fcp2
disabled set fcp2crn [enabled |
disabled]
get fcp2crn
disabled set fcp2conf [enabled |
disabled]
get fcp2conf
BUSY set fcscsibusystatus [busy |
qfull]
get fcscsibusystatus
fctargets <fp>
November 2002
17