Tandberg Data MSERIES FC USER User Manual page 23

Command
SerialNumber
SerialPortBaudRate
SerialPortEcho
SerialPortHandshake
SerialPortStopBits
ServicesLUN
SpeedWrite
SpeedWriteDefault
Temperature
Description
Reports the FC420 board serial
number.
Set the baud rate for the FC420 serial
port (2400, 9600, 19200, 38400, 57600, or
115200).
Turn on or off the echoing of keyboard
input.
Set the data handshaking method used
for controlling the flow between the
transmitter and receiver (hardware,
software, or none).
Set the number of stop bits for the
FC420 serial port (1 or 2).
Identifies the LUNs (one per Fibre
port) to be used during an in-band
command line interface (CLI) session
with a given host. This information is
taken from NVRAM.
Any map coinciding with a user-
specified ServicesLUN must first be set
to offline before attempting to change
the ServicesLUN. This map will be
destroyed upon power-cycling the
Fibre bridge. Disabling a ServicesLUN
for a particular Fibre port will destroy
the map to the Fibre bridge for that
port.
Enables/disables SpeedWrite
functionality to any SCSI device
currently mapped to the Fibre bridge.
To enable/disable SpeedWrite for a
particular device, specify the SCSI bus
(sb), the target (st), and the LUN (sl).
Specify "all" to enable/disable this
option for all currently mapped SCSI
devices.
Enables/disables SpeedWrite
functionality as a default condition
when SCSI devices are mapped to the
Fibre bridge.
Reports the unit temperature in
degrees C.
FC420 Services Software Commands
Tandberg Data FC420 Bridge Option User's Guide
Document T6423053-01, Ver. 1, Rel. 0
Default Syntax
get serialnumber
9600 set serialportbaudrate [rate]
get serialportbaudrate
disabled set serialportecho [enabled |
disabled]
none set serialporthandshake [hard
| xon | none]
get serialporthandshake
1 set serialportstopbits [1 | 2]
get serialportstopbits
8 set serviceslun [fp] [[fl] |
disabled]
get serviceslun <[fp]>
set speedwrite [sb st sl | all]
[enabled | disabled]
get speedwrite [sb st sl | all]
disabled set speedwritedefault
[enabled | disabled]
get speedwritedefault
get temperature
November 2002
23