Verifying Current Fc420 Firmware; Setting Local Echo Mode; Scanning The Scsi Buses On The Library - Tandberg Data MSERIES FC USER User Manual

Tandberg Data FC420 Bridge Option User's Guide
Document T6423053-01, Ver. 1, Rel. 0
November 2002
Figure 5 Telnet Window
Showing Connection with
FC420
Firmware version
information
Verifying Current
0
FC420 Firmware
Setting Local Echo
0
Mode
Scanning the SCSI
0
buses on the Library
10
The Telnet connection window shows the firmware version and gives
the firmware revision date. See
Use this information to determine if the FC420 Fibre bridge has current
firmware.
If you suspect that the firmware needs to be updated, follow
Note:
the instructions found in
page 12.
To set local echo mode, type
prompt and then press
Use the following procedure to confirm that the SCSI buses are cabled
properly.
At the prompt, type
1
Ready
This command scans and displays all SCSI devices found on SCSI
bus 0.
When the prompt reappears, type
2
Ready
press if the second SCSI port on the FC420 bridge is being
<Enter>
utilized.
Configuring FC420 Firmware
figure 5.
Updating FC420 Firmware
set SerialPortEcho enabled
.
<Enter>
, and then press
scsitargets 0
scsitargets 1
on
at the
Ready
.
<Enter>
, and then