Tandberg Data MSERIES FC USER User Manual page 21

Command
Reserve (Immediate)
Reservation of the FC420 is implicit; once the configuration
image is changed by any user of services (Serial/Ethernet/Etc.,)
the FC420 becomes RESERVED. Performing a
SaveConfiguration, RestoreConfiguration or FcRestart
RELEASES the FC420 so that other devices may access it.
When the FC420 services interface is reserved, set commands are
unavailable, but get commands are available. Note that at least
one service interface always has access to the FC420 at all times.
This interface always reports a RELEASED status, since it may
issue set commands.
RestoreConfiguration
(Immediate)
RouteChange
(Immediate)
RouteDisplay
RouteOffline
RouteOnline
Description
Restore to factory default
configuration or the last saved
configuration. The new configuration
must be saved to take effect.
Map a Fibre Channel port (fp) and
LUN (fl) to a SCSI bus (sb), target (st),
and LUN (sl). Valid route change
entries are:
fp (0-2)
fl (0-31)
sb (0-3)
st (0-15)
sl (0-7).
List the currently mapped Fibre
Channel-to-SCSI routes.
Set the status of a route to offline.
Set the status of a route to online.
FC420 Services Software Commands
Tandberg Data FC420 Bridge Option User's Guide
Document T6423053-01, Ver. 1, Rel. 0
Default Syntax
reserve
restoreconfiguration [default
| saved]
routechange [fp] [fl] [sb] [st]
[sl]
routedisplay
routedisplay [fp]
routedisplay [online | offline]
routedisplay [fp [fl]]
routedisplay [fp [online |
offline]]
set routeoffline [fp] [fl]
get routeoffline [fp] [fl]
set routeonline [fp] [fl]
get routeonline [fp] [fl]
November 2002
21