Tandberg Data FC420 Bridge Option User's Guide
Document T6423053-01, Ver. 1, Rel. 0
November 2002
Command
FcWWName
FibreBridgeModel
FibreBridgeName
FibreBridgeTargetLUN
FirmwareRestart
(Immediate)
Help (Immediate)
IdentifyFibreBridge
Info (Immediate)
18
Description
Sets/displays the current World Wide
Name (WWN) of the Fibre Channel
interface referenced. Each Fibre port
has a unique WWN. The least
significant 6 bits of the WWN are used
as the Ethernet MAC address.
The set variant of the command allows
the user to change the last three bytes
of each WWN. Please note, however,
that the most significant bit of the three
bytes must be 1 in order to provide
WWN verification. Also note that the
last bit of each WWN may only be
assigned one of the following values: 0,
4, 8, or C for port 0; 1, 5, 9, or D for port
1; and 2, 6, A, or E for port 2.
Fabric and loop operation is
unpredictable if duplicate WWNs are
used.
Reports the specific FC420 model
information.
Specify the 8-character name assigned
to the FC420 bridge.
Specify the soft target LUN used by the
FC420 when addressed by the host.
This LUN is taken from NVRAM.
Reboots the FC420 firmware.
Displays a list of available commands.
When the optional command name is
present, detailed command-specific
information is displayed.
Causes the "Fault" LED on the FC420
board to blink continuously until
disabled.
Displays version numbers and other
product information for key
components within the FC420.
FC420 Services Software Commands
Default
Syntax
10 00 0x,
set fcwwname [portnumber
where x
[0xnn 0xnn 0xnn]]
is the
get fcwwname [portnumber]
Fibre
port
number.
get fibrebridgemodel
"........"
set fibrebridgename [name]
get fibrebridgename
0x7
set fibrebridgetargetlun [0 -
31]
firmwarerestart
help [command name]
disabled
set identifyfibrebridge
[enabled | disabled]
Get identifyfibrebridge
info
Need help?
Do you have a question about the MSERIES FC USER and is the answer not in the manual?
Questions and answers