Tandberg Data MSERIES FC USER User Manual page 22

Tandberg Data FC420 Bridge Option User's Guide
Document T6423053-01, Ver. 1, Rel. 0
November 2002
Command
SaveConfiguration
(Immediate)
ScsiInitID
ScsiPortBusSpeed
ScsiPortList
(Immediate)
ScsiPortReset
(Immediate)
ScsiPortResetOnStartup
ScsiPortSelTimeout
ScsiPortSyncTransfer
ScsiPortTaggedQueuing
ScsiPortWideTransfer
ScsiTargets
ScsiTermination
22
Description
Save the new configuration. If a
firmware restart is required to make
the change, the user is prompted to
confirm the restart. The user can
override the confirmation request by
indicating the override value on the
command line.
Specify the SCSI initiator ID to be used
on the specified SCSI port.
Specifies the transfer rate at which the
Fibre bridge will attempt to negotiate
with SCSI devices. The choices are Fast
SCSI, Ultra SCSI, Ultra 2 SCSI, and
Ultra 3 SCSI.
List the available SCSI ports and their
status.
Resets the specified SCSI bus.
Specify whether the SCSI port should
be reset on power-up.
Show the time (msec) that the bridge
waits for a response from a SCSI
device on the selected port after a
selection request.
Specify whether synchronous SCSI
transfers should be negotiated with
devices on the specified SCSI port.
Specify whether tagged command
queuing is allowed on the SCSI port.
Specify whether wide SCSI transfers
should be negotiated.
List the SCSI devices that are on the
referenced SCSI bus.
Set the internal termination of the
referenced SCSI port.
FC420 Services Software Commands
Default Syntax
saveconfiguration < restart |
nonrestart >
0x07 set scsiinitid [sb [0-15]]
get scsiinitid [sb]
ultra3 set scsiportbusspeed
[portnumber [fast | ultra |
ultra2 | ultra3]]
get scsiportbusspeed
[portnumber]
scsiportlist
scsiportreset [sb]
enabled set scsiportresetonstartup [sb
[enabled | disabled]]
get scsiportresetonstartup [sb]
256 msec set scsiportseltimeout [sb [256
| 128 | 64 | 32 | 16 | 8 | 4 | 2
| 1]]
get scsiportseltimeout [sb]
enabled set scsiportsynctransfer [[sb]
[enabled | disabled]]
get scsiportsynctransfer [sb]
disabled set scsiporttaggedqueuing [sb
[enabled | disabled]]
get scsiporttaggedqueuing
[sb]
enabled set scsiportwidetransfer [sb
[enabled | disabled]]
get scsitargets [sb]
enabled set scsitermination [sb
[enabled | disabled]]
get scsitermination [sb]